Sokkia Total Station Cx105 Manual Pdf

Set for topography observation. As this target is made of paper great care must be taken to prevent it getting wet.

Install a target directly below or directly above the point to be found, then use a measuring tape etc. Distance along the baseline from the first point to the position at which a line extending from the required point intersects the baseline at right angles X direction. Sparks could be induced, acrobat x pdf portfolio themes leading to fire.

The coordinates of the target point are displayed. The survey point should remain centered in the reticle.

Search form

Each item can be changed to meet your measurement requirements. Leave a Reply Cancel reply Your email address will not be published. Correct half the deviation with the levelling foot screw. Then set the telescope in the face right position and accurately sight the same target.

SOKKIA Americas / Oceania

First clear all route data. Adjust the levelling foot screws to center the survey point in the optical plummet reticle. Allocate functions to the softkeys.

Sokkia CX Manuals

SOKKIA Global Portal

The instrument station is then moved to the foresight station and the previous instrument station becomes the backsight station. Built-in laser plummet with five brightness levels is equipped for quick instrument setting in all lighting conditions. Incorrect Password Input password does not match set password.

Those are Sokkia traditions. Install the instrument station far from the target. The Z coordinate is found by treating the average value as the instrument station coordinates.

If necessary, repeat the adjustment. It is then possible to proceed with the setting-out of the center peg and width pegs. The lens requires special care. Set up the Instrument at point A and the reflective prism at point B.

Set the following data items. The temperature and air pressure are set to the default setting. Points on an enclosed area are observed in a clockwise or counterclockwise direction. Center point observed first.

After completing the observation, End Topography? Turn off all devices not being used. Eliminates the need for nightly recharging or carrying extra batteries. When a point has been observed more than once, the most recent data will be used for the search. Continue to adjust until the laser beam is on the horizontal line of the target.

Sokkia CX-105 Manuals

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Greatly reduces likelihood of low power during any full-days work. Cross-sections can be surveyed in a variety of directions depending on your requirements.

Metal chassis and heavy duty handle add ruggedness. Make sure the legs are spaced at equal intervals and the head is approximately level. Sight the target at the target point.

When the plate level adjustment screw is turned in the counterclockwise direction, the bubble moves in the same direction. Not only does it allow you to measure precisely to corners and walls, but it can even measure around tree branches and through chain-link fences. Make sure that the tightening tension for both screws is identical. Use of this technology must be compliant with telecommunications regulations of the country where the instrument is being used.

It is impossible to read in data. Doing so could cause permanent eye damage. The height of the target is calculated using the following formula. Dual-axis compensator ensures stable measurements even when setup on uneven terrain.

It must be inspected and adjusted before use so that it always performs accurate measurements. Input the same password twice.

Set the known point coordinate. It also enables you to measure the horizontal angle between two points and set the horizontal angle to a required value. The measurement results are displayed.

Atmospheric correction factor can also be entered directly. Enter backsight point coordinates.